does anyone have the all - 31 iv - timid seed, that was around 114 frames.
Akiratron said:does anyone have the all - 31 iv - timid seed, that was around 114 frames.
mattj said:d2140289
Akiratron said:does anyone have the all - 31 iv - timid seed, that was around 114 frames.
Steveebomb7134 said:Is this what your looking for?
Heres a Site for Searching for Spreads
http://dppt.x-treem.nl/?pagina=zoeken&zoeken=careful&hp=31&atk=31&def=31&spatk=&spdef=31&speed=0&type
Steveebomb7134 said:Is this what your looking for?
Heres a Site for Searching for Spreads
http://dppt.x-treem.nl/?pagina=zoeken&zoeken=careful&hp=31&atk=31&def=31&spatk=&spdef=31&speed=0&type
mattj said:I wish that was stickied in the OP. That site would have saved me tons of time had I known about it before.
Steveebomb7134 said:Lol me too, for some reason the link i downloaded for the Spreads are all Jumbled up.... Like there not ordered Alphabetically on my Computer X_x wouldve saved me some time........
Akiratron said:same also - it would take ages to search through them. that page should be put on the first page of the research thread for sure.
43R0D4CTYL said:yes but only in areas that have wild pokemon, grass ,cave ,water, etc and at times it may even advance it by 2 but that's on rare occasionsWhen I simply do a step forward, does this raise my frame by 1?
Charzaro said:I ended up killing the roamer and doing 18 flips. My question is, what did I do wrong? I ended up either 1 frame after or 3 before.Ok, so I'm trying to rng regigigas. i found a really good spread on a low frame. (31/31/30/20/30/31 on 37)For some reason I can't seem to get to the right rng advances. What am I doing wrong?
37
-1for monster
-1 for 1 roaming poke
-3 for 3 turns in front of regigigas(where wild pokes are)
-32 for 16 journal flips
Charzaro said:I ended up killing the roamer and doing 18 flips. My question is, what did I do wrong? I ended up either 1 frame after or 3 before.
Jawshua said:128 steps with 5 pokes = 1 frame advancement
Jawshua said:So, I'm trying to figure out how to use emloop to hit higher delays today, and I've come across a problem. When I get to this step (in Syberia's guide):
I get a seconds value of 12.95. I adjust my pre-delay time to 60.2 to account for the adjacency of my seconds result to 13. My problem, however, is that I can't hit a target time of 13 seconds. My typical seconds range is 14-15. What do I need to adjust in order to make this work?